But what if only 2 leaves are allowed to traverse that final gap, there might be much less of a fight. Why is this so hard? Well, typically all the leaves will bind up when reaching minimum aperture, because they’re all fighting over the same space. Happy with that, I then set about devising a way to get the aperture to close that last few stubborn millimeters. Next I logged into the Iris Calculator (of course!) and punched in the numbers to get me quickly in the ball-park of an iris that would fit on top as a lid. A quick rough 3D print confirmed it would be a suitable and functional size to hold and operate. ![]() This gave plenty of internal volume to contain the ring, with enough ‘meat’ to build the box and iris around it. Using a typical ring size as a starting point, I settled on the outside dimensions of 60 mm x 40 mm for the box. I also wanted to have the rim of the iris as thin as possible to maximise internal space, without increasing the external size of the box. Some additional ideals were to have it fully 3D printable on an FDM (Fused Deposition Modeling) 3D printer – which meant it needed minimal overhangs, and likely use the leaf printing technique to skirt around the opposing pins printing problem. It also had to be a size to minimise fumbling when operating under excited – and let’s face it – stressful conditions. Conversely, though, not so small that it takes away any of the ‘wow’ factor during a proposal. The previous version was on the large-size, and ideally I wanted this one to be able to be carried a little more stealthily if needed. More on this later…įinally, I wanted to make sure it’s relatively practical to carry. In fact they stubbornly refuse, and will gladly damage their own leaves permanently, rather than willingly comply with having their aperture fully-closed.īut really, a box should be able to shut properly – especially a box with life altering precious cargo! So I wanted to design in a way that closes the hole in the aperture completely. Next, I wanted to address one of the most frequently requested things an iris is expected to be able to do, and that is to close completely! This is something irises (the overlapping leaf variety) typically don’t like doing. This not only adds to the drama of the reveal, but also from a practical point-of-view, as it makes it much easier to take the ring out of the box (and put it in to begin with). So I set out a small list of ideal requirements:įirstly, the ring had to rise up. There are some other great looking ones already available out there on the internet, and inevitably some of those features have been requested of me since. I have designed one in the past (which you can also 3D print), and although it functions well, I felt there’s plenty of room for improvement. ![]() A challenge I set myself recently was to create the best engagement ring box possible.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |